Fast Eddy, Tappet Roller Rebuild Tool (No. 25)

Used to remove & install the tappet rollers. Will drill out old axle ends, drive out old axle, installs new rollers and sets ends of new axle. Currently the best tool available for a professional result. - Fast, easy, and precise replacement of tappet rollers.- Fits lifters with a .730" to.740" body diameter, .850" to .855" roller diameter, and .355" to .370" roller width - Will not fit Evo or Twin cam lifters - Precision machined with very tight tolerances for a perfect fit - Lifter will not move around when performing operations - Type III mil spec hard anodized finish for incredible durability - Easily clamps into vise to make the whole job easy - USA made. Instructions how to use. Step 1: drill out ends of old axle. Use included 7/32" drill bit and drill about 1/16" into each side of the old tappet axle. Lightly oil the drill bit before putting in through the hardened drill bushing. Be sure to blow chips out in between drilling the two sides of the lifter. Step 2: Drive out old axle. Carefully drive out the old tappet axle using the included pin punch. This should take a few firm strikes from a 16oz ballpeen hammer. If 2-3 firm strikes aren''t enough to start moving the old axle out, take out the lifter and move it back to station/step 1 and drill out a little more of the end of the axle before continuing again to step 2 and driving the axle out. Step 3: Install new roller assembly and set the ends of new axle. Install new/replacement roller assembly and

36-84 Big Twin (Excl. Evo), 57-85 XL Sportster. (Excl. Evo, Flatheads, Twin Cam) (NU)